Table of Contents
Advertisement
CHANGING THE OPERATING PATTERN
6.4.1 HOW TO CHANGE THE OPERAT-
ING PATTERN
After stopping the machine on a firm and level surface, lower
the equipment to the ground, stop the engine and lock the con-
trols by lifting the safety bars in vertical position.
Open the engine hood and proceed as follows:
1 - Loosen the safety screw (3) that holds the selection lever
(2) in position.
Use a 13 mm hexagon wrench.
2 - Select the desired operating pattern by rotating the lever
(2) to position "A" for the ISO PATTERN or to position "B"
for the OPTION PATTERN.
3 - Secure the lever in the selected position with the safety
screw (3).
IMPORTANT
Before moving the machine, the operator must make su-
q
re that the selected operating pattern corresponds to
the one desired.
The control panels (4) positioned at the sides of the cen-
tral dashboard are backlit.
The lighting of the plates is useful for the operator to
q
identify the type of operating system selected. (ISO PAT-
TERN or OPTION PATTERN control system).
226
3
2
A
B
2
4
RKAB1410
RKAB1390
RKAB1400
4
RKAB1420
Advertisement
Table of Contents
