Table of Contents
Advertisement
3.6.6 HOW TO MOVE THE MACHINE (OPTIONAL PATTERN CONTROL SYS-
TEM)
The procedures to be followed to use any control systems different from the ISO and OPTION PATTER-
q
NS are described in section "OPTIONAL EQUIPMENT" (See "6.5 HAND & FOOT CONTROL SYSTEM").
Carefully read and be sure to understand the contents of this section before using the machine.
Before moving the machine, make sure that you know the control functions and all the relevant safety
q
regulations perfectly.
The operator must be seated in the driving position with fastened safety belt.
q
Before moving the machine, check the position of the rear-view mirrors and make sure that there is no
q
one within the operating radius of the machine and that there are no obstacles in the surrounding area.
Be extremely careful when engaging the reverse and make sure that there are no persons, working me-
q
ans or obstacles in the way.
Avoid manoeuvres or changes of direction when travelling at full speed, since the manoeuvres carried
q
out in these conditions cause abrupt movements.
Do not use the speed increase function when changing direction or carrying out a counter-rotation.
q
The use of the speed increase function is allowed only for the fast speed transfers of the machine.
q
Before moving the machine, check the instruments, warm up the engine and the hydraulic system oil, make sure
that the safety device of the controls is released (safety bars down) and the bucket is folded; the equipment control
levers must be in neutral position.
Release the parking brake.
1 - Pull the hand accelerator lever and set the engine running
at idling speed.
CAUTION
WARNING
USE OF THE MACHINE
RWA32510
115
Advertisement
Table of Contents
