Optional: Installing The Foam Cover; Cockpit App; System Requirements; Initial Connection Between Cockpit App And Prosthesis - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

7.2 Optional: Installing the foam cover

If a cosmetic foam cover is installed on the knee joint, the charging receptacle has to be moved with the following
charging cable extensions:
• 4X156 Charger Extension Cable – Ankle
• 4X158 charger extension cable – ankle, long
• 4X157 Charger Extension Cable – Knee
Further information on the installation and use of the charging cable extensions is found in the instructions for use
included with the charging cable extensions.

8 Cockpit app

The cockpit app enables switching from basic mode into the pre-configured MyModes. In
addition, information about the product (step counter, battery charge level, etc.) can be
called up.
The behaviour of the product can be changed to a certain extent on a day-to-day basis
using the app (e.g. while becoming accustomed to the product). The adjustment software
can be used to trace the change at the patient's next appointment.
INFORMATION
The Cockpit app can be downloaded free of charge from the respective online store. For more information,
please visit the website: http://www.ottobock.com/cockpitapp. To download the Cockpit app, the QR code on the
supplied Bluetooth PIN card can be read with the mobile device (requirement: QR code reader and camera).
INFORMATION
The language of the Cockpit app user interface can only be changed using the adjustment software.
INFORMATION
The serial number of the component to be connected has to be registered with Ottobock the first time it is con­
nected. If the registration is not accepted, use of the Cockpit app for this component will be limited.
INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (sole of the foot must point
up) or by connecting/disconnecting the battery charger. Bluetooth is then turned on for approx. 2 minutes. During
this time, the app must be started and used to establish a connection. If required, Bluetooth on the prosthesis can
be switched on permanently afterwards (see Page 33).

8.1 System Requirements

The functioning of the Cockpit app is assured on devices that support the following operating systems:
iOS (for iPhone, iPad, iPod): version 9.3 or higher. The mobile device has to support Bluetooth 4.0 (BT LE).
•
Android: version 4.0.3 or higher
•

8.2 Initial connection between cockpit app and prosthesis

The following points should be observed before the initial connection:
• Bluetooth of the component must be switched on (see Page 33).
• Bluetooth of the device must be switched on.
• The device must not be in "flight mode" (offline mode), otherwise all wireless connections are turned off.
• The device must be connected to the internet.
• The serial number and Bluetooth PIN of the component being connected must be known. They are found on
the enclosed Bluetooth PIN card. The serial number begins with the letters "SN".
INFORMATION
If the Bluetooth PIN card with the Bluetooth PIN and serial number of the component is lost, the Bluetooth PIN
can be determined using the adjustment software.
C-Leg 3C98-3/3C88-3
Cockpit app
25