Table of Contents
Advertisement
2 - SETTING THE RANGE OF MOTION (ROM)
eccentric phase, the lever moves within the set range. Please be particularly careful
in doing this, because the incorrect setting angles could result in serious damage to
the articulation of the patient.
For the correct setting angles limit is necessary to set the correct angle of the limb:
➢
Bring the leg in flexion angle limit and press the Auto button next to the
command setting the limiting flexion.
Bring the leg angle limit extension and press the Auto button next to the
➢
command setting the limiting extension.
You can also set the angles through the sliders in the same manner just described
for the setting of all the other parameters.
To continue with the exercise, you need to enable the range of motion (ROM) by
clicking on the ball to the left of the command.
3 - ENABLE/DISABLE ACTIVE ROM (range of movement) –
range within which the exercises data will be processed. The default setting is 10%
less than the arc of movement set with the key 2, to eliminate any artifacts
generated by the inversion of motion (inversion of the direction of rotation of the
motor)
4 - ENABLE/DISABLE TORQUE LIMIT – It
the maximum torque that can reach the patient. If the limit is enabled and the
patient exceeds the set limit the exercise is stopped immediately.
Click on the arrow at the bottom right to continue with the exercise.
5.4.4 Exercise in progress
When the page opens press the START button wait beep / light from the system
and start operation;
The exercise itself starts as soon as the patient makes the first move. During the
exercise appear in real time the histograms of the maximum torque value (peak
torque) of each movement.
Depending on the type of motion is set to have different results.
Easytech s.r.l. – Genu Iso/Plus User's Manual
-
Set the joint range. During the
will indicate on the chart during operation
rev. C
If enabled, it limits the
Pag. 48 di 97
Advertisement
Table of Contents
