Table of Contents
Advertisement
Position the patient following the instructions provided, extend the limb, press
button 1 (COMPENSATE) and wait for the device to perform the compensation
without forcing the operation (2 sec).
If the patient is the same, it is not necessary to repeat this operation at the
beginning of each exercise, because the parameters are stored in the memory of the
device. The therapist should compare the resulting value with the historical values
to verify that the calibration is correct.
A confirmation screen will be displayed at the end of the operation:
5.3.1.4 Exercise in progress
Once all the settings have been completed, press the arrow at the bottom right to
access the page relating to the exercise.
Press START, wait for the device to issue an acoustic/visual signal, then start the
exercise.
The actual exercise starts when the patient makes the first movement. During the
exercise, the system displays in real time the histograms of the maximum torque
values (peak torque) applicable to each movement.
Easytech s.r.l. – Genu Iso/Plus User's Manual
rev. C
Pag. 35 di 97
Advertisement
Table of Contents
