Adjustments For Static Exercises; Possible Faults; Communication Error - easytech Isokinetic Genu Iso User Manual

4.3.3 Adjustments for static exercises

For instructions on how to set the isometric function during static exercises, refer to
the previous figure.
Move the selector to position ON and lock the lever in place at the desired angle (0°-
90° in steps of 15°) to perform the isometric exercise.
Move the selector to position OFF to release the lever and perform dynamic exercises
(isokinetic, hydrodynamic and isotonic).

4.4 POSSIBLE FAULTS

4.4.1 Communication error

The communication between the two units is controlled upon start-up and when a
new exercise/test is started.
In case of communication error between Pc and Genu unit, the following error will be
displayed and in the program screen there will be a red writing in the upper right
corner under the Easytech logo (Device not Connected):
Easytech s.r.l. – Genu Iso/Plus User's Manual
rev. C Pag. 25 di 97
