easytech Isokinetic Genu Iso User Manual page 26

Possible causes can be:
1. The USB Cable is not connected to the computer
2. The device is not turned on
3. The emergency button is pressed
Check the USB connection, turn on the device or release the emergency button and
press "Retry".
If the program does not detect the device, set the parameters as indicated in Appendix
1 to the paragraph relating to the start of the program with an error message.
In some cases of communication error, the following error message may appear:
In these cases, write down the message on a note pad, and continue operating by
pressing the "Continue" button.
Contact customer service if the error repeats frequently.
Easytech s.r.l. – Genu Iso/Plus User's Manual
rev. C

Pag. 26 di 97