Setting The Limits - easytech Isokinetic Genu Iso User Manual

Position the patient following the instructions provided, extend the limb, press
button 1 (COMPENSATE) and wait for the device to perform the compensation
without forcing the operation (2 sec).
If the patient is the same, it is not necessary to repeat this operation at the
beginning of each exercise, because the parameters are stored in the memory of the
device. The therapist should compare the resulting value with the historical values
to verify that the calibration is correct.
A confirmation screen will be displayed at the end of the operation:

5.4.3 Setting the limits

Clicking on the right arrow you proceed with the execution of the exercise, passing
through the page of the range of motion setting (ROM).
1 – GONIOMETER THAT INDICATES THE ANGLE- check the correct indication
Easytech s.r.l. – Genu Iso/Plus User's Manual
rev. C Pag. 47 di 97
