Instructions For Use - Otto Bock 4R118 Instructions For Use Manual

Unacceptable environmental conditions
Solids: dust, sand, highly hygroscopic particles (e. g. talcum)
2.4 Lifetime
This product was tested by the manufacturer with 3 million load
cycles. Depending on the user's activity level, this corresponds to a
maximum lifetime of 5 years.
3 Safety
3.1 Explanation of warning symbols
Warning regarding possible risks of accident or
CAUTION
injury.
Warning regarding possible technical damage.
NOTICE
3.2 General safety instructions
CAUTION!
Risk of injury and risk of product damage
► Comply with the product's field of application and do not expose
it to excessive strain (see page 7).
► Note the combination possibilities/combination exclusions in the
instructions for use of the products.
► Do not expose the product to prohibited environmental condi­
tions.
► Check the product for damage if it has been exposed to prohib­
ited environmental conditions.
► Do not use the product if it is damaged or in a questionable con­
dition. Take suitable measures (e.g. cleaning, repair, replace­
ment, inspection by the manufacturer or a specialist workshop).
► Observe the maximum lifetime of the product.
► To prevent mechanical damage, use caution when working with
the product.
8
► If you suspect the product is damaged, check it for proper func­
tion and readiness for use.
► Do not use the product if its functionality is restricted. Take suit­
able measures (e.g. cleaning, repair, replacement, inspection by
the manufacturer or a specialist workshop).
Signs of changes in or loss of functionality during use
Among other factors, changes in functionality can be indicated by an
altered gait pattern, a change in the positioning of the prosthetic com­
ponents relative to each other and by the development of noises.
4 Scope of delivery
Quantity Designation
1

Instructions for use

1 Adapter plate
4 Cap screw
4 Cap screw
4 Cap screw
4 Countersunk head screw
4 Countersunk head screw
5 Preparing the product for use
CAUTION
Incorrect alignment or assembly
Risk of injury due to damaged prosthetic components
► Observe the alignment and assembly instructions.
5.1 Preparing the prosthetic socket
The distal end of the prosthetic socket is ground to ensure full-surface
contact of the adapter plate.
4R118
Reference num­
ber
–
–
501T61=M6x12
501T61=M6x25
501T61=M6x30
501S41=M6x12
501S41=M6x16