Search Mode - Xantrex Freedom EX 4000 Owner's Manual

ELECTRICAL SHOCK HAZARD
Turning the Power k button to Standby does not disconnect DC
battery power from the Freedom EX 4000. You must disconnect
from all power sources before working on any circuits connected to
the unit.
Failure to follow these instructions can result in death, serious
injury, or equipment damage.
To prevent unnecessary battery discharge, press the Power
button to Standby when you are not using the Freedom EX 4000.
975-0999-01-01
WARNING

Search Mode

When a single Freedom EX 4000
What is Search
Inverter/Charger with 48VDC-to-12VDC
mode
Converter has search mode enabled, the
inverter sends electrical search pulses
through its AC output. These search pulses
look for connected AC loads. The delay
between search pulses is set using the
Search Delay setting. After a load larger than
the Search Threshold setting is detected, the
inverter starts producing AC output.
The search mode feature is only valuable if
When to set up
the inverter can spend a fair amount of time

Search mode

"sleeping" each day. Therefore, if search
mode is to be used it must be adjusted
properly. The initial adjustment should be
made so that the Freedom EX 4000 comes
on only when needed.
Certain types of loads can cause search
mode to work improperly. These types of
loads are described in Problem Loads on
page 48. If these kinds of loads are in the
system, follow the suggestions given to
resolve the problem.
Operating in Battery Mode
17