Xantrex Freedom EX 4000 Owner's Manual page 68

Warning Messages
Table 7 Event codes displayed on the LCD screen
Event Code Event Type
E - Escalating Auto Fault. See Action for more detail.
F - Manual fault. Unit operation stops. See Action to remedy the condition and clear the Alert LED on the unit. See Clear Faults and Warnings on page 41.
W - Warning. Unit operation continues.
W/F - Unit operation continues with a warning until a manual fault is triggered. See Action to remedy the condition and clear the Alert LED on the unit. See Clear Faults
and Warnings on page 41.
F
51 to 56
F
57
F
58
F
59
F
60
F
61
F
62
E
63
E
64
E
65
52
Condition
EEPROM Error
FET1 Over Temperature
Shutdown
FET2 Over Temperature
Shutdown
Manual Configuration
Unit Fault
Unit Fault
Unit Fault
AC Overload
AC Overload Line 1
AC Overload Line 2
Mode
Any mode No action. Clear fault and resume operating or configuring the unit.
If the fault persists, have the unit serviced.
Any mode Reduce the loads connected to the AC outlet of the unit. Check that
the ventilation grille is not blocked. Check for ambient temperature
and move the unit to a cooler location whenever possible. Check
Any mode
the fan for any obstruction and remove it.
Any mode Auto-configuration process failed. Retry auto-configuration or
configure the unit manually.
Any mode Clear faults/warnings and restart. If error persists, contact
customer service.
Any mode Clear faults/warnings and restart. If error persists, contact
customer service.
Any mode Clear faults/warnings and restart. If error persists, contact
customer service.
Any mode Must occur 3 times in 5 minutes before becoming a manual fault.
Check for loads above the inverter's capacity, turn off some loads if
Any mode
necessary. Power down and restart the unit to clear the manual
fault.
Any mode
Action
Freedom EX 4000 Owner's Guide