Configuring The Charger Mode - Xantrex Truecharge TC1012 Installation Manual
Truecharge 2 series battery charger
Hide thumbs
Also See for Truecharge TC1012:
- Owner's manual (80 pages) ,
- Owner's manual (80 pages) ,
- Installation manual (66 pages)
Table of Contents
Advertisement
Configuring the Charger Mode
Using the Onboard Display Panel
To configure the charger mode:
Note: By default, the Charger Mode is set to three-stage.
1. Press and hold the Charger Mode Select button for three
2. Select the proper charger mode.
Figure 2-5 Onboard Display Panel
975-0402-01-01
This guide for use by qualified installers only
Configuring the Truecharge™ 2 Battery Charger
seconds.
The LEDs will indicate which of the two modes is being
selected: three-stage (default) or two-stage.
2–27
Advertisement
Table of Contents
