Xantrex Freedom EX 4000 Owner's Manual page 66

Warning Messages
Table 7 Event codes displayed on the LCD screen
Event Code Event Type
E - Escalating Auto Fault. See Action for more detail.
F - Manual fault. Unit operation stops. See Action to remedy the condition and clear the Alert LED on the unit. See Clear Faults and Warnings on page 41.
W - Warning. Unit operation continues.
W/F - Unit operation continues with a warning until a manual fault is triggered. See Action to remedy the condition and clear the Alert LED on the unit. See Clear Faults
and Warnings on page 41.
E
1
E
2
F
9
F
17 and 19
F
18 and 20
F
21
F
22
50
Condition
AC Output Under Voltage
AC Output Over Voltage
BMS Node Missing for CVCC
mode
Relay(s) Welded
Relay(s) Welded
Relay(s) Welded
Relay(s) Welded
Mode
Any mode Must occur 3 times in 2 minutes before becoming a manual fault.
Clear the fault and attempt to restart. Contact customer service if
problem persists.
Any mode Must occur 3 times in 2 minutes before becoming a manual fault.
Clear the fault and attempt to restart. Contact customer service if
problem persists.
Shore (AC) mode This fault triggers when the charger stage is set to CVCC but there
is no BMS node found on the network.
Shore (AC) mode The AC L1 transfer relay is bad or an AC source was wired directly
to the AC output. Disconnect the inverter's output wiring. If error
continues, have unit serviced.
Shore (AC) mode The AC L2 transfer relay is bad or an AC source was wired directly
to the AC output. Disconnect the inverter's output wiring. If error
continues, have unit serviced.
Shore (AC) mode The AC L1L2 transfer relay is bad or an AC source was wired
directly to the AC output. Disconnect the inverter's output wiring. If
error continues, have unit serviced.
See 17.
Shore (AC) mode
Action
Freedom EX 4000 Owner's Guide