5.6.4 Updating the sensors
45
Sensor firmware is available.
Insert the sensors into the base
station and do not shut off the
system during the update process.
Update later
+ + : If there is a firmware update, insert the switched on sensors in the base station and tap the
►
"Update now" button.
►
: Confirm the displayed message with "OK" and wait until the firmware update has been installed on the
sensors.
5.7 Troubleshooting
The following subsections contain further information on eliminating errors:
•
"User interface system messages" (see page 36)
•
"Fault table" (see page 37)
•
"Measures" (see page 39)
•
"Replacing faulty product components" (see page 40)
743A250 Bionic Pro
Update now
The switched on sensors must be in the
base station. Do not turn off the system
during the process.
OK
Use
35