System Information; Adjusting The Settings - Otto Bock Bionic Pro Instructions For Use Manual

Use

5.5.5.2 System information

33
System
information
Version:
Serial:
Available memory:
Local IP address:
Date/time:
Attention: all data including the patient and
measurement data will be erased.
Tapping the "System information" button displays important system information.
► Only tap the "Reset"
including the patient and measured data will be deleted and cannot be retrieved again. – After tapping
the button, the word "RESET" also has to be entered to confirm that the base station should really be reset.)
The following important information is displayed for all sensors, that are switched on and connected to the base
station via Wi-Fi:
: Battery icon displays the charge level.
: Version number of the sensor firmware.
: Button – tapping this button causes the LED of the corresponding sensor to flash in the colour pink for several
seconds.
: Internal number of the sensor.

5.5.5.3 Adjusting the settings

34
Change
settings
Tapping the "Adjust settings" button lets you make changes for the following areas:
: Language (German / English) – language for the user interface, online help, digital instructions for use, applic­
ations and reports
: Change date format (DD.MM.YYYY / MM/DD/YYYY)
: Change time format (24h / 12h)
: System of units (metric system / imperial system)
: Market (EU / USA) – an FES application is only possible if "EU" is selected in combination with a suitable
orthosis.
: Company information - For entering company information in order to show it on the PDF reports.
28
1234567.bionicpro.local
System information
XXXX.XX.XX+XXXXXXX
Thigh, left Foot, right Calf
XXXXX
v.XX.X.X v.XX.X.X
v.XX.X.X
XX.XX GB
XXXXXXXX XXXXXXXX XXXXXXXX
XXX.XXX.XXX.XXX
XX.XX.XXXX, XX:XX
Thigh Pelvis Calf, left
v.XX.X.X v.XX.X.X v.XX.X.X
Reset base station
XXXXXXXX XXXXXXXX XXXXXXXX
Reset
Foot, left
v.XX.X.X
XXXXXXXX
?
Enter user name
button when you want to completely reset the base station (Please note! All data
1234567.bionicpro.local
Change settings
Regional Settings Set password
Language
German
Select date format
DD.MM.YYYY
E-mail address for security code
Select time format
24h
Request security PIN
Unit system
Company information
Metric system
Enter your company information in order to show it
on the PDF reports.
Market
EU
Enter company information
Show help for measurement
?
Enter user name
100 %
Reset base station
Attention: all data including the patient and
measurement data will be erased.
100 %
Language
German
Select date format
DD.MM.YYYY
Select time format
24h
Unit system
Metric system
Market
EU
Reset
Company information
743A250 Bionic Pro
P Sensor
v.XX.X.X
XXXXXXXX