Charging Sensors In The Base Station And Switching Them On Prior To Measuring - Otto Bock Bionic Pro Instructions For Use Manual

4.5 Charging sensors in the base station and switching them on prior to measuring

11
: Check whether all the LEDs on the base station are illuminated ( : Power LED;
►
tem status LED).
► : NOTICE! Only charge sensors in the base station. Refer to the ambient temperature for charging in the
"General safety instructions" (see page 6) section under the "Ambient conditions" heading.
INFORMATION: The charging time for the sensors is approx. 4 hours.
: For measuring pull the charged sensors out of the base station.
►
► : Switched on sensor
: Switch on the switched off sensors with a fine-tip pen or a similar pointed tool or object prior to measuring.
►
LED signal
Not illuminated
Illuminated
Flashing slowly
Flashing quickly
743A250 Bionic Pro
Meaning of the base station LED signals
: Power LED
No power supply connected
Power supply connected
: WLAN LED
WLAN connection to router
established
WLAN connection to router
interrupted, base station set­
ting up own WLAN network
WLAN connection to router
being established
Preparing the product for use
: WLAN LED; : Sys­
: System status LED
Boot process completed,
base station ready
Base station booting
15