Advertisement
Available languages
Available languages
Battery empty
Battery 50% charged
Battery fully charged
8.4 Safety Shutoff
The purpose of the safety shutoff is to protect the battery; it is triggered in case of:
•
Excessively high or low temperature during charging
•
Short circuit
•
Overvoltage or undervoltage
INFORMATION
After a safety shutdown, the battery charger must be connected to reactivate the electronics.
8.5 Beeper Functions
The following beeper functions are set by default:
Switch on the prosthesis:
Press button for more than 1 second.
Switch off the prosthesis:
Press button for more than 1 second.
Connect charging plug:
Charging begins.
Disconnect charging plug:
Charging ends.
The following beeper functions exist only in conjunction with the 9E420=* 7in1 Controller:
Parental access switch
Connect the MyoLino Link
Disconnect the MyoLino Link:
Prosthesis was previously switched on
Disconnect the MyoLino Link:
Prosthesis was previously switched off
9 Cleaning
1) Clean the product with a damp, soft cloth.
2) Dry the product with a soft cloth.
3) Air dry to remove residual moisture.
20 | Ottobock
Red LED is illuminated
Yellow LED is illuminated
Green LED is illuminated
One long beep
One long beep Two short
beeps
Two short beeps
Continuous
pulses
(as long as
the button is
being
pressed)
Advertisement
