YASKAWA SI-EN3/V Technical Manual page 44

10 Input Assemblies (Drive Produces)
Parameter
Torque Reference
PG Count Value
Frequency Command
Output Frequency
Output Current
INV Terminal A1 Input
Main DC Voltage
Error Code
F7-33 Alarm Code
F7-34 Output Power
F7-35 Terminal A2 Input
F7-36 INV Terminal 1-12
F7-37 Terminal A3 Input
F7-38 PG Count Value (CH 2)
F7-39 NetRef (Status)
F7-40 Drive Software Version
44
Not Supported on V1000
Contained MEMOBUS/Modbus Address
Monitor parameter U1-01
Actual Drive Speed
Monitors drive output frequency.
Unit depends on o1-03.
Unit is not affected by Speed Scale SS.
Actual Output Current
Monitors drive output current.
Unit is 0.01 A
Unit is not affected by Current Scale CS.
MEMOBUS/Modbus (0x46)
Monitor parameter U1-13
Main Circuit DC Voltage
Monitor parameter U1-07
U2-01 converted using fault code table
Programmable: MEMOBUS/Modbus (0x7F)
Programmable: MEMOBUS/Modbus (0x47)
Monitor parameter U1-08
Programmable: MEMOBUS/Modbus (0x4F)
Monitor parameter U1-14
Programmable: Only 1 - 7 available on V1000, MEMOBUS/Modbus (0x49)
Monitor parameter U1-10
Programmable: MEMOBUS/Modbus (0x50)
Monitor parameter U1-15, not supported on V1000
Programmable: MEMOBUS/Modbus (0xF1)
Serial interface Control Response
Status of reference command from Network
0: Reference command is not from network
1: Reference command is from network
Programmable: MEMOBUS/Modbus (0x4D)
Monitor parameter U1-25
YASKAWA ELECTRIC SIEP YEACOM 01A V1000 Option EtherNet/IP Technical Manual
Data