YASKAWA SI-EN3/V Technical Manual page 13

Do not operate damaged equipment.
Failure to comply may cause further damage to the equipment.
Do not connect or operate any equipment with visible damage or missing parts.
Do not use unshielded cable for control wiring.
Failure to comply may cause electrical interference resulting in poor system performance.
Use shielded twisted-pair wires and ground the shield to the ground terminal of the drive.
Properly connect all pins and connectors.
Failure to comply may prevent proper operation and possibly damage equipment.
Check wiring to ensure that all connections are correct after installing the option unit and connecting any other
devices.
Failure to comply may result in damage to the option unit.
Wiring Diagram
<1> The FE terminal on the EtherNet/IP Option is supplied with a ground wire that should
Prior to Installing the Option Unit
Prior to installing the EtherNet/IP Option, wire the drive and make necessary connections to the drive terminals. Refer to
the Quick Start Guide for information on wiring and connecting the drive. First, verify that the drive functions normally
without the option installed.
YASKAWA ELECTRIC SIEP YEACOM 01A V1000 Option EtherNet/IP Technical Manual
Power
EtherNet/IP Master EtherNet/IP Cable
be connected to the ground terminal on the drive.
Figure 4 Wiring Diagram
NOTICE
R U
S V
T W
V1000
<1>
SI-EN3/V
EtherNet/IP
Option
5 Installation Procedure
M Motor
FE
13