Operation Environment - Raycus ABP Series User Manual

with its connector staying away from collision and vibration. Please DO NOT distort, bend, or pull the
delivery cable when unpacking the device; and avoid any collision to the quartz or protective cap of laser
emission.

2.4 Operation Environment

The required operation conditions are listed as in the Table 1:
Model
Supply Voltage
Power Supply Capacity
Water Cooling Flow
Installation Environment
Ambient Temperature
Relative Humidity
a) Make sure the product is properly grounded before use.
b) Thefiber delivery cable connector is well connected with the fiber optic cable (delivery cable). Please
inspect the fiber delivery cable connector carefully for dust or other contaminations. Use appropriate
lens cleaning paper to remove the dust before laser emission.
c) Failure to follow the instructions when using the laser may cause malfunction or damage.
d) DO NOTinstall the fiber delivery cable connector during laser emission.
e) DO NOT watch the fiber delivery cable connector lens directly if the laser is powered on. MUST
wear the appropriate protective goggles all the time when operating the laser.
TIPS:
Install the laser in an air-conditioned environment will offer the product to benefit a longer life and
better performance.
CAUTION: The fiber delivery cable and its connector are precise optic
instrument, any vibration or impact to the fiber delivery cable or connector, twist
or excessive bend will damage the product.
Table 1 Operation conditions for the laser
1500/1500 2000/2000
Three-phase four-wire, AC 323V~AC 437V, 50/60Hz (with PE)
＞15 kVA
> 18 kVA
＞35 L/min
> 35 L/min > 52 L/min
Wuhan Raycus Fiber Laser Technologies Co., Ltd.
User Guide of RFL-C3000XZ~RFL-C12000XZ
3000/3000 2000/4000
> 25 kVA > 25 kVA
> 52 L/min
Flat, no vibration nor impact
10℃ ~ 40 ℃
＜70%
6
4000/2000 4000/4000
> 25 kVA > 35 kVA
> 52 L/min > 64 L/min
6000/6000
>50 kVA
> 94 L/min