Viewing The Variables; Watch] Window - Renesas H8 Series User Manual

5.6

Viewing the Variables

This section describes how you can look at variables in the source program.
5.6.1

[Watch] Window

You can view any value in the [Watch] window.
The [R] mark shows that the value of the variable can be updated during user program execution.
For updating of the content of the variable that has been registered in the [Watch] window, there are the
following three methods:
1. Use the Monitor function without halting the user program
The read/write signal of the MCU is set as a trigger and holds the address bus and data bus values to update the
value of the variable.
Note: Although the realtime operation is retained, the size and number points to be monitored are limited. For
the Monitor function, refer to section 5.5, Displaying Memory Contents in Realtime.
58
Figure 5.18 [Watch] Window