Copying A Configuration File From A Flash Memory Card To Rp Nvram - Cisco 12404 Installation And Configuration Manual

Chapter 3 Installing the Cisco 12404 Internet Router
Step 2
Copying a Configuration File from a Flash Memory Card to RP
NVRAM
Step 1
OL-11636-01
To further verify that the file was copied correctly, enter the dir command at the
privileged EXEC mode prompt:
Filo# dir slot0:
-#- -length- -----date/time------ name
1 5200084 May 10 2002 19:24:12 gsr-p-mz.112-8
3 1215 May 10 2002 20:30:52 myfile1
4 6176844 May 10 2002 23:04:10 gsr-p-mz.112-8.1
5 1186 May 10 2002 16:56:50 myfile2
9197156 bytes available (11381148 bytes used)
Filo#
To copy a configuration file from a Flash memory card in PCMCIA slot 0 or slot 1
to NVRAM, follow these steps.
Enter the command for copying a configuration file from a Flash memory card to
NVRAM. This command takes the following form:
copy [slot0:|slot1:]filename startup-config
Where:
[slot0: | slot1:]filename
startup-config
Cisco 12404 Internet Router Installation and Configuration Guide
Copying a Cisco IOS Software Image
Specifies the source of the configuration file to be
copied (the Flash memory card inserted in either
PCMCIA slot 0 or slot 1) and the name of the
new file.
Specifies the destination (NVRAM) of the file to
be copied.
3-86