Table of Contents
Advertisement
Operation is performed as programmed in this mode as shown in the diagram below.
Start pv
(Temp)
Step 1
Program start
Setting the program operation
1 Turning power on
＊Register a program prior to starting a program operation.
2 Registering a program
Step 2
Step 4
Step 3
You can set up to 99 steps for a program and can save
up to 99 program patterns.
（The maximum number of steps that can be saved is
99, which means you can save 10 patterns of programs
when each pattern uses nine steps.）
※Note that you cannot use cross-repeating or setting of
multiple destinations for return when you use the
program repeat function.
Press the
and then press the
4. Operating procedures
Step 5
Step 6
Turn the ELB at the upper right side of the unit "On".
Keeping the
key pressed longer will turn power
on.
Main display shows the internal temperature and the
Sub display shows the set temperature.
key, display [PRoG] in the Sub display
24
Program operation
Set temp.
Step 7
Step 8
（Time）
Program end
key.
Advertisement
Table of Contents
