Yamato INE800 Manual page 65

When specimen spills over
● Clean the inside of the unit. If soil has extended to inside the rectifying board, remove the lower
rectifying board and clean the inside.
・Remove the rectifying boards at the lower part of the inside. They can be separated into front and
rear parts. Remove screws and remove the front rectifying board as shown in the diagram below. If
soil is extensive, remove the rear part and clean the inside.
・Use well wrung out soft cloth to remove soil on the inside.
Caution
・If cleaning is not performed properly, some types of spilt specimen may cause contamination
or other troubles.
・Take extreme care for handling of stainless steel plates.
◆ If you have any questions, immediately contact your dealer, one of our sales offices or our general
customer service center.
Fixing screws(seven
points)
Lift one end and remove
6. Maintenance procedures
Daily inspection/maintenance
61
Rectifying board
(back side)
Rectifying board
(front side)