About The Standalone Overheat Preventive Device - Yamato INE800 Manual

Setting a temperature on the
standalone overheat preventive
device

About the standalone overheat preventive device

Operation may stop when the difference between the set temperature on the standalone
overheat preventive device and that on the controller, which activates the preventive device. Set
the temperature for the standalone overheat preventive device to a temperature by at least 10℃
higher than that of the controller. Note that the standalone overheat preventive device cannot be
employed for protecting specimens. The factory setting of the temperature is 75℃. The settable
range is between 0℃ and 75℃.
If you want to operate the standalone overheat preventive device at a temperature you want,
first operate the unit with its inside being stably kept at that temperature, slowly lower the setting
on the standalone overheat preventive device and make sure that it securely operates at the
desired temperature and then start operating. Wait for five seconds until the unit starts to
operate before checking. When the device is activated, Er07 is indicated and operation will stop.
When you have changed the set temperature on the standalone overheat preventive device,
registration of the temperature takes about five seconds during which you should wait before
turning its power off.
4. Operating procedures
About the standalone overheat preventive device
* Setting a temperature with the ▼▲ keys.
58