Electrical installation
Contents of this chapter
This chapter contains general cabling instructions and instructions on connecting the
FMBT-21 module to the Ethernet network and the drive.
Necessary tools and instructions
See the drive hardware manual.
General cabling instructions
•
Arrange the bus cables as far away from the motor cables as possible.
•
Avoid parallel runs.
•
Use grommets at cable entries.
Connecting the FMBT-21 to the Ethernet network
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or
death, or damage to the equipment can occur.
Choose correct cable for your application, CAT5e and CAT6 cables are recommended
for industrial applications. ABB recommends to use double shielded twisted pair
cables, eg. "SF/FTP".
Electrical installation 23
5
11