ABB FMBT-21 User Manual page 28

28 Modbus/TCP – Start-up
No. Name/Value Description
1...31 Subnet mask in CIDR notation
10 GW address 1 IP gateways connect individual physical IP subnets into a unified
IP network. When an IP node needs to communicate with an IP
node on another subnet, the IP node sends the data to the IP
gateway for forwarding. Parameters 10...13 define the four octets
of the gateway address.
0...255 GW address
... ... ...
13 GW address 4 See parameter 10 GW address 1.
0...255 GW address
14 Commrate port Sets the bit rate for the Ethernet port 2.
2
0 = Auto Auto-negotiate
1 = 100 Mbps FD 100 Mbps, full duplex
2 = 100 Mbps 100 Mbps, half duplex
HD
3 = 10 Mbps FD 10 Mbps, full duplex
4 = 10 Mbps HD 10 Mbps, half duplex
15 Service configur- Disable services that are not required. Each service is represented
ation by a single bit. Bit 0, Lock configuration, can be used to prevent
accidental changing of this parameter. By default, all services are
enabled and configuration is unlocked.
Bit Name
0 Lock configuration
1 Disable IP config tool
2 Disable ETH tool net-
work
3 Disable ping response
4 Unsecured ETH tool
network
5 Disable configuring
web pages
0000b... 1111b Service configuration
Information
Changing this bit to one will lock service configuration and
no bit can be changed. Only resetting the fieldbus configura-
tion will unlock the parameter. To reset the fieldbus configur-
ation, choose "Reset all fieldbus settings" or "Clear all" in
parameter 96.06 Parameter restore.
When this bit is set, access from ABB IP Configuration tool is
prevented.
When this bit is set, access from Ethernet tool network (eg,
ABB Drive Composer tool) is prevented.
When this bit is set, response to ICMP (ping) message is pre-
vented.
When this bit is set, access from Ethernet tool network is un-
secured.
Note: Drive Composer pro before V2.7 supports unsecured
communication only.
When this bit is set, access to web pages is disabled.
Default
0
...
0
0 = Auto