Electrical Installation; Overview; General Cabling Instructions; Ethernet Connection - ABB FENA-01 Hardware Manual

Ethernet adapter module

Hide thumbs Also See for FENA-01:

Table of Contents

Electrical installation

This chapter contains:

• instructions for connecting the module to the Ethernet.

WARNING! Before installation, switch off the drive power supply.

Wait 5 minutes to ensure that the capacitor bank of the drive is

discharged. Switch off all dangerous voltages connected from

external control circuits to the inputs and outputs of the drive.

General cabling instructions

Arrange the bus cables as far away from the motor cables as

possible. Avoid parallel runs. Use bushings at cable entries.

The network cable is connected to the RJ45 connector (X1) on the

FENA-01 module. Standard CAT5 UTP, FTP or STP cables can be

used.

When CAT5 FTP or STP is used, jumper J1 connects the cable

shield internally either:

• to the drive frame (position 1-2) or

• through an RC network to drive frame (position 2-3).

Electrical installation

Table of Contents