ABB FMBT-21 User Manual page 62

62 NONE – Start-up
No. Name/Value
10 GW address 1
...
13
0...255
...
GW address 4
0.255
14 Commrate port 2
0 = Auto
1 = 100 Mbps FD
2 = 100 Mbps HD
3 = 10 Mbps FD
4 = 10 Mbps HD
15 Service configuration
Bit Name
0 Lock configuration
1 Disable IP config tool
2 Disable ETH tool net-
work
3 Disable ping response
4 Unsecured ETH tool
network
5 Disable configuring
web pages
0000b...1111b
Description
IP gateways connect individual physical IP subnets
into a unified IP network. When an IP node needs
to communicate with an IP node on another subnet,
the IP node sends the data to the IP gateway for
forwarding. Parameters define the four octets of
the gateway address.
GW address
...
See parameter 10 GW address 1.
GW address
Sets the bit rate for the Ethernet port 2.
Autonegotiate
100 Mbps, full duplex
100 Mbps, half duplex
10 Mbps, full duplex
10 Mbps, half duplex
Disable services that are not required.
Each service is represented by a single bit. Bit 0,
Lock configuration, can be used to prevent accident-
al changing of this parameter.
By default, all services are enabled and configura-
tion is unlocked.
Information
Changing this bit to one will lock service configuration and
no bit can be changed. Only resetting the fieldbus configura-
tion will unlock the parameter. To reset the fieldbus configur-
ation, choose "Reset all fieldbus settings" or "Clear all" in
parameter 96.06 Parameter restore.
When this bit is set, access from ABB IP Configuration tool
is prevented.
When this bit is set, access from Ethernet tool network (eg,
ABB Drive Composer tool) is prevented.
When this bit is set, response to ICMP (ping) message is
prevented.
When this bit is set, access from Ethernet tool network is
unsecured.
Note: Drive Composer pro before V2.7 supports unsecured
communication only.
When this bit is set, access to web pages is disabled.
Service configuration
Default
0
...
0
0 = Auto