Aatnn - ICP DAS USA I-87211W User Manual

2.24 ~AATnn

Description:
This command is used to set the "Soft INIT" duration. The
command "~AAI" must be send to set the module to "INIT"
mode before using this command (See Section 2.23). The
BaudRate and checksum can then be changed using the
"%AANNTTCCFF" command (See Section 2.1).
Syntax:
~AATnn[CHKSUM](CR)
~ Delimiter character
AA Address of the module in hexadecimal format (00
to FF)
T Command to set the Soft INIT duration
nn Two hexadecimal digits that represent the
Soft INIT duration
The maximum duration is 60 seconds
Example: a value of 10 = 16 seconds
Response:
Valid Command:
Invalid Command:
! Delimiter for a valid command
? Delimiter for an invalid command
AA Address of the module in hexadecimal format (00
to FF)
!AA[CHKSUM](CR)
?AA[CHKSUM](CR)
77/93 I-87211W User Manual V2.5, Oct. 2010
I-87211W User Manual