ICP DAS USA I-87211W User Manual page 33

Related Commands:
Refer to Section 2.9 $AA2, Section 2.23 ~AAI, and Section
2.26 ~AATnn
Note:
1. Changes to the address settings take effect
immediately after a valid command is received.
Changes to the Baud Rate and checksum settings take
effect on the next power-on reset.
2. In order to chang the Baud Rate, checksum settings or
others, the module needs to be in Init mode. Another
way is to send the following commands beforehand.
I. Send command ~AATnn (Refer to Section 2.27)
II. Send command ~AAI (Refer to Section 2.26_
III. Send command %AANNTTCCFF
If these commands are valid, the Baud Rate, checksum
or others will take effect after the module responds
with "!AA".
33/93 I-87211W User Manual V2.5, Oct. 2010
I-87211W User Manual