Ethercat slave modules with digital inputs and outputs (48 pages)
Summary of Contents for ICP DAS USA I-7050D
Page 1
1. Introduction I-7050D is intelligently designed to provide signal conditioning system monitoring and safe value settings. I-7050D is a cost-effective solution for a wide range of valuable industrial control signals and systems. The DCON utility can help users to configure and test I-7050D Digital Input/Output modules.
Page 2
3. Block/ Wiring Diagram I-7050D - 7 Ch DI and 8 Ch DO DAQ Module- QuickStart (Nov/2017) ICP DAS USA, Inc. | www.icpdas-usa.com | 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717...
3. Connect the module to the power supply using the +Vs and GND terminals. Note that the voltage supplied should be in the range of +10 to +30V DC. I-7050D - 7 Ch DI and 8 Ch DO DAQ Module- QuickStart (Nov/2017) ICP DAS USA, Inc.
Page 4
The default settings for the module can be found in Section 3. Click OK after selecting the COM port setting. I-7050D - 7 Ch DI and 8 Ch DO DAQ Module- QuickStart (Nov/2017) ICP DAS USA, Inc. | www.icpdas-usa.com...
Page 5
DCON Utility Pro supports DCON and Modbus protocol for all ICPDAS and the others modules. 6. Configuration I/O module setting on PC I-7050D - 7 Ch DI and 8 Ch DO DAQ Module- QuickStart (Nov/2017) ICP DAS USA, Inc. | www.icpdas-usa.com...
Page 6
If user doesn’t know command, user can select Address and ID, it will show some refer commands as below. User can select necessary command to test or debug modules. I-7050D - 7 Ch DI and 8 Ch DO DAQ Module- QuickStart (Nov/2017) ICP DAS USA, Inc. | www.icpdas-usa.com...