Allied Systems W8L Service Manual page 121

5. Remove the intermediate shaft cover.
6. Tag shims for reference during reassembly (not
shown).
NOTE: The above step is relevant only to AW8L-2032
and below without exterior freespool drag adjust.
Exterior freespool adjust covers do not require shims.
7. Screw a 3/4-10 UNC slide hammer into the end of
the intermediate shaft and partially pull it out.
8. Remove the drum pinion gear and the inner
bearing cone. Refer to Figure 4-3 for the location of
components.
8. Remove bearing cup and cone and the intermediate
shaft, while ensuring that the intermediate gear does
not fall.
10. Remove intermediate gear.
NOTE: Remove drum shaft retainer prior to removing
intermediate gear. See Drum Shaft and Drum Removal
subsection that follows.
Section 4
4 - 25