Cleaning - AGFA DR 100s User Manual

66 | DR 100s | Introduction

Cleaning

To clean the exterior of the equipment:
1. Stop the system.
2. Wipe the exterior of the device with a clean, soft, damp cloth. Use a mild
soap or detergent if required. Do not use any corrosive, dissolving or
abrasive cleaning or polishing agents. Make sure no liquid gets in the
device.
Using unsuitable cleaning agents or methods can damage the property
when surface becomes dull and brittle (e.g. alcohol-containing agents).
3. Start up the system.
Topics:
• Cleaning chromed parts
• Cleaning plastic surfaces
• Cleaning enameled or aluminum parts
• Cleaning the tube head display during operation
• Cleaning the exposure button
Cleaning chromed parts
Chromed parts must be cleaned only with a dry woolen cloth. Do not use
polishing abrasives. To protect the finish, use a nonabrasive wax.
Cleaning plastic surfaces
Plastic surfaces must be cleaned only with soap and water. When using other
cleaning agents (for example with a high alcohol content), the material can
become opaque or can break.
0411D EN 20220627 1040
WARNING:
When the equipment is going to be cleaned, be sure to turn
OFF the power of each device, and to unplug the power cord
from the AC outlet. Otherwise, it may result in fire or electric
shock.
CAUTION:
Clean the equipment with only a little moisture.
Note: Do not open the equipment for cleaning. No components
inside the device require cleaning by the user.