AGFA DR 100s User Manual page 67

Cleaning enameled or aluminum parts
Enameled parts and aluminum surfaces must be cleaned only with a damp
cloth and a mild detergent and then with a dry woolen cloth. Never use
scouring powders, solvents, abrasives detergents or polishing abrasive. Do not
use a special detergent if its properties are not sure.
Cleaning the tube head display during operation
To clean the tube head display during operation
1. Press and hold the cleaning button for 2 seconds.
Figure 35: Cleaning button
A black screen hides the screen and shows a number counting down.
2. Clean the display.
The operation is not affected.
3. The display can be used again after the countdown has finished.
Cleaning the exposure button
When removing dirt, wipe the exterior of the device with a clean, soft, damp
cloth. Use a mild soap or detergent if required. Make sure no liquid gets in the
device. Wipe dry with a dry cloth. When using detergent, please do not use
detergent other than neutral detergent. Use of spray cleaning agents can cause
malfunctions due to ingress of the liquid into the equipment.
DR 100s | Introduction | 67
0411D EN 20220627 1040