About Data - Unipulse F701-P Operation Manual

Holding register
4XXXX
B1: 1 bit I16: 16-bit integer I32: 32-bit integer
Point

■About data

Data type
Gross display
Net display
One-touch tare subtraction
One-touch tare subtraction reset
Digital zero
Coil Digital zero reset
Hold ON
Hold OFF
Accumulation clear
Zero calibration
Span calibration (actual load calibration) Executes span calibration (actual load calibration).
NEAR ZERO
HI
GO
LO
SP1
SP2
Input status
SP3
COMPL.
STAB
HOLD
ZT
TARE
85
40056
40057
40058
40059
40060
40061
40062
－
49999
The address number used on a message is a relative address.
The relative address is calculated by the following equation.
Relative address = Last 4 digits of address No. - 1
For example, it is 0014 (0x0E) when holding register 40015 is designated.
Data name
LOCK1, 2
External input selection
External output selection
Min scale division
DZ regulation value
Accumulation count (read only)
Reserve (no assignments)
Meaning of data
Switches the weight display to gross weight.
Switches the weight display to net weight.
Executes one-touch tare subtraction.
Resets one-touch tare subtraction.
Zeroes gross weight.
Resets digital zero.
Holds weight value.
Cancels weight value hold.
Clears accumulation value.
Executes zero calibration.
Indicates the state of the NZ signal of the indicator.
Indicates the state of the over signal of the indicator.
Indicates the state of the go signal of the indicator.
Indicates the state of the under signal of the indicator.
Indicates the state of the SP1 signal of the indicator.
Indicates the state of the SP2 signal of the indicator.
Indicates the state of the SP3 signal of the indicator.
Indicates the state of the complete signal of the indicator.
Turns ON while weight value of the indicator is stable.
Turns ON while weight value is held.
Turns ON while zero tracking of the indicator is in operation.
Turns ON when tare subtraction is performed.
9 RS-485 INTERFACE
Unsigned
No
I16
decimal
point
85
Chapter
9