Table of Contents
Advertisement
2-2.
Connection of the load cell,
power input terminal,RS-485 and
external input/output signal terminal blocks
1.
2.
3.
4.
5.
6.
7.
Attention
11
Peel the sheath of the wire to be
connected 5mm, and twist the end to such
an extent that it will not become loose.
Remove the terminal block from the
F701-P body with a strong pull.
Loosen the screw with a screwdriver to
open the hole.
A Phillips screwdriver with a shaft diameter
of 3 - 3.5mm #1 is recommendable.
(precision screwdriver, etc.)
Insert the wire into the hole so as not to
loosen the end.
Tighten the screw with the screwdriver.
Lightly pull the wire to check that it is
clamped securely.
* Connectable wires are 0.21 - 3.31mm
(AWG12 - 24).
Recommendable tightening torque is 0.5Nm.
Insert the wire-connected plug into
the F701-P body, and tighten the
screws (two).
When mounting the terminal block to the
F701-P body, check its vertical orientation.
(See the illustration on the right-hand side.)
Turn counterclockwise.
Hole
Turn clockwise.
2
Screws (two)
Turn clockwise.
UP
DOWN
2 CONNECTION
Chapter
Insertion side
11
2
Advertisement
Table of Contents
