Table of Contents
Advertisement
4-3.
Preparation before calibration
■LOCK release
Calibration values and setting values can be locked so as not to be changed by misoperation.
In LOCK, there is software LOCK applied by setting. To perform calibration, release the lock.
1.
2.
Now, the LOCK is released. Upon completion of calibration, apply the LOCK to protect the
calibration values.
Point
■Unit display (setting mode 4-5)
Set the unit for weighing.
Select the unit from 0: None/1: t/2: g/3: kg/4: lb.
■Decimal place (setting mode 4-5)
Set the decimal place common to weight-related displays and setting items, etc., by this selection.
Select the decimal place from 0: None/1: 0.0/2: 0.00/3: 0.000.
Point
25
Select setting mode 3-6(LOCK).
Set the setting LOCK2 to OFF.
LOCK
For the LOCK and setting values protected, see "11-1.List of setting values" on
page 97.
Display selection
Display selection
In the F701-P, the decimal place is fixed for all other than weight-related data.
* It cannot be changed.
4 CALIBRATION
LOCK2
0: OFF
1: ON
Unit
0: None
3: kg
1: t
4: lb
2: g
Decimal place
0: None
1: 0.0
2: 0.00
3: 0.000
Chapter
4
25
Advertisement
Table of Contents
