When Comparison Mode 1 (Over/Under Comparison Mode) Is Set; When Comparison Mode 2 (Discharging Control Mode) Is Set; Stable; Weight Error - Unipulse F701-P Operation Manual

■When comparison mode 1 (over/under comparison mode) is set

HI, GO, LO
Each signal turns on under the following condition.
- HI:
- GO:
- LO:

■When comparison mode 2 (discharging control mode) is set

COMPL, SP3, SP2, SP1
Each signal turns on under the following condition.
- COMPL:
- SP3:
- SP2:
- SP1:
Point

■Stable

The output turns on when the weight value is stable.
* For details, see "5-6.Motion detection(MD) (setting mode 1-5, 2-3)" on page 33.

■Weight error

The output turns on when the display is LOAD, OFL, or ZALM (zero alarm).
* For error displays, see "11-2.Over scale/error display" on page 100.

■Total limit

If the total comparison selection setting is "Total comparison ON" or "Count comparison ON," the
output turns on under the following condition.
ON condition
- Total comparison ON: The output turns on when the accumulation value ≧ total limit setting value.
- Count comparison ON: The output turns on when the accumulation count ≧ count limit setting value.
53
8 EXTERNAL INPUT/OUTPUT SIGNALS (CONTROL CONNECTOR)
Weight value ＞ (Target value + Over)
(Target value - Under) ≦ Weight value ≦ (Target value + Over)
Weight value ＜ (Target value - Under)
While the COMPLETE signal is output
Weight value ≧ Final - Compensation
Weight value ≧ Final - Set point 2
Weight value ≧ Final - Set point 1
- If Set point 1 = 0, Set point 2 = 0, the SP1, SP2 signal are not output constantly.
- Determine the COMPLETE signal output timing by weighing function 1
(setting mode 1-4).
- The next weighing is regarded as being able to be started only when the weight
value once falls below 25% of the final setting value after outputting the
complete signal. If the start of weighing cannot be judged, the complete signal
cannot also be output.
Chapter
8
53