External Input Signals; Gross/Net Switch (G/N) <Edge Input; Digital Zero (D/Z On) <Edge Input; Tare Subtraction (Tare On) <Edge Input - Unipulse F701-P Operation Manual

8-3.

External input signals

■Gross/net switch (G/N) <edge input>
Net weight display is brought about at the ON edge.
Gross weight display is brought about at the OFF edge.
■Digital zero (D/Z ON) <edge input>
The gross weight is zeroed at the ON edge.
The same operation is also performed with the
Valid" by setting mode 3-5).
What can be zeroed is within the range of DZ regulation value. If out of this range, zero will not
result, but "
■Tare subtraction (TARE ON) <edge input>
Tare subtraction is immediately performed and the net weight is zeroed at the ON edge.
The same operation is also performed with the
Valid" by setting mode 3-5).
* During tare subtraction, "
■Tare subtraction reset (TARE OFF) <edge input>
The above tare subtraction is reset at the ON edge.
The same operation is also performed by pressing the
key is set at "1: Valid" by setting mode 3-5).
51
8 EXTERNAL INPUT/OUTPUT SIGNALS (CONTROL CONNECTOR)
Net weight display
OFF
ON
" flashes.
OFF
ON
" lights.
OFF
ON
OFF
ON
Gross weight display
OFF
ON
key (only when the ZERO key is set at "1:
Pulse width 50msec or more
key (only when the TARE key is set at "1:
Pulse width 50msec or more
key (only when the TARE RESET
Pulse width 50msec or more
Chapter
8
51