Table of Contents
Advertisement
■Setting section
Setting method
Storage of setting values
Protection of setting values
Setting items
■External signals
Source type or sink type selected at order-time.
- Output signals
Output type
Number of outputs
Isolation method
Rated input voltage
Operating voltage range
Max. voltage
Max. current
- Input signals
Input type
Number of inputs
Isolation method
Rated input voltage
Operating voltage range
Load current
91
Settings are made by membrane key operation.
Also, settings can be made from a host computer through
RS-485 I/F, etc.
Stored in F-RAM (nonvolatile RAM)
Software LOCK of a set value and the calibration value is possible.
Upper limit/ Lower limit/ Near zero/ Set point 1/ Set point 2/
Compensation/ Over/ Under/ Final/ Comparison inhibit time/
Judging time/ Complete output time (Hold time)/ Weighing
function 1/ Weighing function 2/ Tare setting/ Tare display/
Digital low-pass filter/ Moving average filter/ Motion detection
(Period - Range)/ Zero tracking (Period)/ Zero tracking (Range)/
Total comparison selection/ Total limit (high 4)/ Total limit
(under 5)/ Count limit/ Key invalid/ LOCK/ External input selection/
External output selection/ PASSWORD/ Balance weight value/
Capacity/ Minimum scale division/ DZ regulation value/
Display selection/ Gravitation acceleration/ RS-485 I/F/
Communication type/ RS-485 ID/ Transmission delay time/
Span calibration/ Zero calibration
When each signal turns ON, the output transistor turns ON.
* There is a need to prepare an external power supply.
4 points
Photocoupler isolation
DC24V
DC20.4 to 26.4V (ripple percent within 5%)
DC30V
DC120mA
Contact (relay, switch, etc.) or non-contact (transistor,
photocoupler, etc.) connectable
* There is a need to prepare an external DC power supply.
4 points
Photocoupler isolation
DC24V
DC20.4 to 26.4V (ripple percent within 5%)
Approx. 11mA (when 24V DC load)
10 SPECIFICATIONS
91
Chapter
10
Advertisement
Table of Contents
