Connection - Unipulse F701-P Operation Manual

2

CONNECTION

Precautions about connection to the signal input/output terminal block are given below.
The precautions described here are important for safety.
Please properly understand the descriptions before connection.
- Do not connect a commercial power source directly to the signal input/output
terminals.
- Connect to the signal input/output terminals with no power applied because it may
cause an electric shock.
- For connection to the signal input/output terminals, check the signal names and pin
assignment numbers, and then carry out wiring properly.
- Before applying power, carefully check the wiring, etc.
- Do not touch any signal input/output terminal while applying power.
Doing so may cause electric shocks or malfunctions.
- Tighten the terminal screws at the specified torque.
If they are loose, shorts, fire or malfunctions may occur.
Tightening torque: 0.5N• m
- Use shielded cables.
7
WARNING
CAUTION
2 CONNECTION
Chapter
7
2