Communication Type - Unipulse F701-P Operation Manual

■Communication type

- Communication type 0 (mode=0: Command)
Communication is performed with the command from the host computer.
(Weight data is not transmitted automatically.)
Terminator is selectable from CR or CR + LF.
- Communication type 1 (mode=2: Continuous, format=0: Gross weight)
Gross weight is transmitted continuously.
Various commands of R, W, and C are all ignored.
- Communication type 2 (mode=2: Continuous, format=1: Net weight)
Net weight is transmitted continuously.
Various commands of R, W, and C are all ignored.
- Communication type 3 (mode=2: Continuous, format=2: Gross weight + net weight)
Gross weight and net weight are transmitted continuously.
Various commands of R, W, and C are all ignored.
- Communication type 4 (mode=1: Auto, format=0: Gross weight)
Gross weight is transmitted once with the timing of accumulation.
Various commands of R, W, and C are all ignored.
- Communication type 5 (mode=1: Auto, format=1: Net weight)
TNet weight is transmitted once with the timing of accumulation.
Various commands of R, W, and C are all ignored.
- Communication type 6 (mode=1: Auto, format=2: Gross weight + net weight)
Gross weight and net weight are transmitted once with the timing of accumulation.
Various commands of R, W, and C are all ignored.
57
Transmission on format 1
Transmission on format 2
Transmission on format 3
Transmission on format 1
Transmission on format 2
Transmission on format 3
9 RS-485 INTERFACE
(24byte)
(24byte)
(26byte)
(24byte)
(24byte)
(26byte)
57
Chapter
9