Rs-232 Serial Input/Output Connectors; Scsi Connectors; Table 1-4. Serial I/O Pins - HP Visualize c3650 Supplementary Manual

product information
System Unit Rear Panel Connectors
an external transceiver. The workstation automatically selects the correct network setting.

RS-232 serial input/output connectors

There are a variety of peripheral devices that can attach to the RS-232 Serial
Input/Output (SIO) ports on this workstation. Refer to the label on the rear of the
workstation to locate serial port 1 and serial port 2. Peripheral devices include printers,
plotters, modems, and scanners. Consult the documentation that accompanies each
peripheral device for specific information concerning its use.
The SIO ports are programmable, allowing functions such as bit rate, character length,
parity, and stop bits to be set using the System Administration Manager (SAM) or by
selecting a system special device file with the functions already programmed. The SIO
Ports are used as interfaces for serial asynchronous devices to the CPU.
Table 1-4. shows the SIO connector pin listings. The serial connectors are 9-pin D-sub
connectors. Signal names are those specified in the EIA RS-232 standard.

Table 1-4. Serial I/O Pins

Pin No. Signal
1 DCD
2 RXD
3 TXD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 RI

SCSI connectors

The c-class workstation has built in SCSI connectors for Ultra2 Wide Low-Voltage
Differential (LVD) SCSI and Ultra Narrow Single-Ended (NSE) SCSI. Use the SCSI
connectors to connect external SCSI devices such as DDS-format tape drives and CD-ROM
drives. Consult the documentation that accompanies each SCSI device for specific
information concerning its use. Refer to Appendix B, SCSI Connections, for information
about connecting SCSI devices to your workstation.
NOTE There must ALWAYS be a terminator at both ends of a SCSI bus. This means
one internal terminator and one external terminator.
28
Description
Data Carrier Detect
Receive Data
Transmit Data
Data Terminal Ready
Ground
Data Set Ready
Request To Send
Clear To Send
Ring Indicator
Chapter 1