Displaying And Setting Paths; Table 6-1. System Paths; Table 6-2. Mnemonic Style Notation - HP Visualize c3650 Supplementary Manual

boot console handler

displaying and setting paths

displaying and setting paths
A path is the hardware address of a device that is attached to the I/O system of your
workstation. The path command sets the system paths shown in Table 6-1.
The path command sets and displays the hardware address of a specified device attached
to the I/O bus of your workstation.

Table 6-1. System Paths

Path Type
primary or pri
alternate or alt
console or con
keyboard or key
To display the current settings for the system paths, type the following at the prompt and
press :
Enter
Main Menu: Enter command > path
The paths are displayed in Mnemonic Style Notation, as shown in Table 6-2.

Table 6-2. Mnemonic Style Notation

I/O
Built-in LVD SCSI
Built-in NSE SCSI
Optional SCSI
Built-in LAN
Built-in IDE
To display the current setting for a particular system path, follow the directions in
"accessing the boot console handler" earlier in this chapter, and then type the following at
the prompt and press
Main Menu: enter command > path path_type
where path_type is one of the path types listed in Table 6-1.
For example, to get the path to the primary boot device, follow the directions in "accessing
boot console handler" earlier in this chapter, and then type the following at the prompt and
press :
Enter
Main Menu: Enter command > path primary
168
Device
Your workstation's default boot device (usually the root disk)
Your workstation's alternate boot device (usually a DDS-format tape
device)
Your workstation's primary display device
Your workstation's primary ASCII input device
Specification Format
fwscsi. scsi_address . logical_unit_number
scsi. scsi_address.logical_unit_number
pci n . scsi_address.logical_unit_number
lan. server_address . init_timeout . io_timeout
IDE
:
Enter
Chapter 6