System Power Switch; Storage Device Controls And Features; Figure 1-2. Lcd Symbols - HP Visualize c3650 Supplementary Manual

product information
system unit front panel controls

Figure 1-2. LCD Symbols

system power switch

Use the Power switch to power the system unit on and off. When you use the soft power
down procedure, the HP workstations' c-class hardware is designed to produce the proper
diagnostic and self test messages, and broadcasts a warning message to remote terminals
that it is about to shutdown. The operating system executes an automatic shutdown -q
command. Turning the power switch back on again automatically boots up the HP-UX
operating system if the system has been configured to auto boot. For information on
setting auto boot, refer to the section "setting the auto boot and auto search flags" on
page 178.

storage device controls and features

This workstation allows either or both of the following internal storage devices: CD drive
or floppy disk drive. The following sections describe the controls and features of these
devices.
NOTE You cannot have two internal storage devices of the same type. For example,
you cannot have two floppy disk drives, and you cannot have two CDROMs.
Figure 1-3. shows the operating controls and features of the CD drive, and Table 1-1.
describes those controls and features.
22 Chapter 1