Figure 4-10. Removing The Power Supply - HP Visualize c3650 Supplementary Manual

Figure 4-10. Removing the Power Supply

Spring Lever
closing the system
Once you have completed the task you set out to perform, you are ready to close the
system. To close the system follow these steps:
1. Pick up the power supply by its handle and slide the power supply pivot hole over the
right side hinge pin.
2. Position the left end of the power supply in its proper location and release the hinge
lever by lifting it up and allow the hinge pin to spring back into place. Adjust the angle
of the power supply until the bail drops into the bail bracket. It will now remain in
place.
3. Replace all power supply and sensor cables as shown in Figure 4-9. Make sure the
cables are positioned so they will not be damaged by power supply movement.
4. Grab the handle of the power supply and lower it into its original operating position.
See
Figure 4-7.
5. Tighten both captive screws in place as seen in
Replace the left side panel to the system unit as shown in the section "closing the left
6.
side panel of the system unit" in this chapter.
Chapter 4
Spring Hinge
Bail Lock
FRU removal and replacement
Power Supply
Bail
Figure 4-7.
field replaceable units
Right Hinge
105