Power Switch And Led; Disconnecting The Power Switch Cable From The System Board - HP ProLiant ML310 Maintenance And Service Manual

Removal and Replacement Procedures

Power Switch and LED

IMPORTANT: To completely remove all power from the server, you must disconnect the power cord
from the server.
To remove the power switch:
1. Complete the preparation procedures. Refer to "Preparation Procedures" in this chapter.
2. Remove the access panel. Refer to "Access Panel" in this chapter.
3. Disconnect the power switch cable from the system board.
Figure 2-17: Disconnecting the power switch cable from the system
board
2-24 HP ProLiant ML310 Server Maintenance and Service Guide