Renesas Solution Starter Kit for RX23W
4. Smart Configurator Using the e
studio
2
4.5.3
Interrupt Controller
Referring to the RSSK schematic, SW1 is connected to IRQ1(P31) and SW2 is connected to IRQ0 (P30).
Click 'Add component'
icon. In 'Software Component Selection' dialog -> Type, select 'Drivers'.
Select 'Interrupt Controller' as shown in Figure 4-15 then click 'Next'.
Figure 4-15 Select Interrupt Controller
In 'Add new configuration for selected component' dialog -> Resource, select 'ICU' as shown in Figure 4-16
below then click 'Finish'.
Figure 4-16 Select Resource – ICU
R20UT4449EG0100 Rev. 1.00
Page 21 of 64
Aug.30.19