Dynamic IP Address Setting
®
Connect 2N
IP Vario to the power supply (or, disconnect and reconnect it if already
connected).Follow the instructions below to enable automatic getting of network parameters
from the DHCP server:
•
Wait for the first acoustic signal
•
Press following buttons sequentially:
•
2, 1, 1, 2, 2, 3 for 3-buttons models
•
5, 4, 4, 5, 5, 6 for 6-buttons modely
•
The acoustic signal
•
Wait until the device is restarted automatically.
Note
•
The 2, 1, 1, 2, 2, 3 sequence must be entered within 30 seconds after the first sound
signal for security reasons. The inter-digit delay may be 2 s at most.
®
2N
IP Vario gets the IP address upon restart only if the DHCP server is configured properly.
Mode Switching with 1-Button Models
®
Connect 2N
IP Vario to the power supply (or, disconnect and reconnect it if already
connected).In case your 2N
modes using one button only.
•
Wait for the first sound signal
•
Press the quick dial button on the main unit 15 times.
indicates mode switching.
®
IP Vario device is equipped with 1 button, you can switch the
.
Installation manual 2N® IP Vario
92 / 113